Cat 5 For Cable Tv
Cat 5 For Cable Tv
CAT 5 for Cable TV is used by the University of Florida’s Health Sciences Center in Gainesville. This center covers more than two million square feet. This fourteen building complex serves the university’s medical, dental, and three other colleges. A twenty-two channel cable television network called HealthNet is sent to thirteen offices and classrooms in three different buildings of the Health Science Center Complex. HealthNet is sent to the three buildings through the complex’s approximately 7,500 network drops which are, also, used for data. More equipment was set up recently, to deliver HealthNet to eighty additional locations in a new health professional, nursing, and pharmacy building. One user of the Lynx Video Network from Lynx Broadband can watch presentations, even on runs as long as 330 feet. The Lynx Video Network sends Video to offices and classrooms on common CAT 5 for Cable TV. Lynx Broadband is a division of BH Electronics based in Minneapolis. Lynx Broadband: Providing CAT 5 for Cable TV - The Lynx Video Network uses a broadband video balun to send analog, digital, or HDTV television on a pair of four of a CAT 5 or CAT 6. - A Lynx Video Hub in the wiring turns a coax input signal into eight or sixteen CAT 5 output signals. A Lynx single port converter put in near the TV will change the CAT 5 signal back to a coaxial form. - The Lynx Video & Data Network presents all the abilities of the Lynx Video Network while at the same time, delivers Ethernet or telephone on the other three pairs in the cable. - Television signals enter the back of the hub through F connectors. Ethernet or phone enters through RJ-45 ports. CAT 5 and CAT 6 outputs have television on pair 4, and offers Ethernet or phone on the other pairs. - At the point of use wallplate converters divide the two signals and turn the video back to coaxial form. Health Sciences Center’s business manager for academic information systems and support, Hansford Tyler, first saw the product at a trade show. After they get the cable signal to the main distribution closet, they use the exact same system as is used for data distribution. Cable television goes out along with telephone and data from CAT 5 for Cable TV. A passive broadband balun, which converts an unbalanced coaxial signal to a balanced signal is the centerpiece of the Lynx Video Network. It will travel on a CAT 5 cable. The process is turned around by a twin balun at the TV end. This product uses air analog signal that doesn’t travel over the data network and in turn, doesn’t slow down the Network. CAT 5 for Cable TV will be easy to install in the older parts and save time and money because CAT 5 has previously been put in for data network.
|